<pre id="lh9h1"><del id="lh9h1"><mark id="lh9h1"></mark></del></pre>

    <pre id="lh9h1"><ruby id="lh9h1"></ruby></pre><pre id="lh9h1"></pre>
    <track id="lh9h1"></track>

      <p id="lh9h1"></p>

      <pre id="lh9h1"><strike id="lh9h1"><ol id="lh9h1"></ol></strike></pre>

        <output id="lh9h1"><del id="lh9h1"><mark id="lh9h1"></mark></del></output>

        Product

        Product

        未標題-4.jpg 


        JUXIN-80

        Pump size:DN80 Flange,Max flow:9600 l/h


        standard:7.5kw Variable frequency motor


        Suction ability up to 9.5   meters and self-priming
        Dry-run   without damage
        For   high viscosity or shear sensitive medium
        No   leaking, no block. No sealing gasket, ball, diaphragm, immersion rotor,   stator and piston etc.
        Pumping   abrasive slurries, corrosive acids, large solids       and gas-liquid mixture.
        No   internal leakage. Flow stability, can accurate and repeatable measurement.   Accuracy ±1%
        No   ancillary equipment, check valves or water flush systems
        Reversing   operation, particle can safety out from suction or discharge pipe
        ◆Minimal   maintenance-just change the hose
        ◆Reliable quality, low using cost


        Flow  rate measured with water of 20℃, out   pressure show as following chart

        jx80參數.jpg


        Product   information

        Inlet/outlet

        DN80 FLANGE


        Motor power

        7.5KW


        Max flow

        11.5 l/min


        Max head

        160m


        Max discharge pressure

        16 Bar


        Lubricant required

        35 L


        Max temperature

        80


        Hose options

        Chlorosulfonated polyethylene rubber(CSM) Natural   rubber(NR)
          foodgrade hose(F NBR)  nitrile   rubber(NBR)  EPDM


        Installation   size (mm)

        40尺寸圖.jpg80參數.jpg 


        ?